This firmware is intended only for Chroma-Q Color Force II Plus  12, 48 and 72

IMPORTANT

To install the firmware, a Chroma-Q Uploader II will be needed.
Follow the upload instructions in the included PDF.

Note: There are two firmware files per fixture: 1 for each of the engine boards and 1 for the addressing board. The order of the updates is not important. 

*******UPDATE ONLY ONE FIXTURE AT A TIME*******
If updating more than one fixture, they must be done one at a time. Attempts to update several fixtures at once will corrupt the firmware. 

After the firmware is installed, do the following to ensure all settings are nominal.
In the DMX Address menu, enter 555 and press Enter, this will sync the engines with the addressing board.
In the menu Setup/Reset, select Default and press and hold Apply until the fixture resets.

After customizing Settings, Modes, Options and DMX Address as needed, the fixture is ready to be used.


*****WARNING*****
DO NOT LOAD THESE FIRMWARE'S ON ORIGINAL COLOR FORCE II OR STUDIO FORCE II


========================================================================================
LED Engine Firmware version: 4.2
	•	File Name: ColorForceII_Plus_Eng_App_v4.2.0.bin
	•	Release Date: 2024-01-22
	•	Compatible Engine PCBs: Color Force II Plus Rev A
	•	Compatible Units: All Color Force II Plus
	•	Changes since the previous release:

## [4.2.0] - 2024-01-22
### Changed
- Initial release
- Corrections applied for CFII Plus Rev A with faceted reflector and lens2.  




========================================================================================	
Addressing Board (Display) Firmware Version:  4.10


	•	File Name: ColorForceII_Plus_Addr_App_12_v4.10 / ColorForceII_Plus_Addr_App_48_v4.10 / ColorForceII_Plus_Addr_App_72_v4.10
	•	Release Date: 2023-09-13
	•	Changes since the previous release:

## [4.1.0] - 2023-09-13
Initial release 

For any additional info, contact us at info@Chroma-q.com
